Planet Minis - View Single Post - Two Brothers Exhaust / Muffler and Header Pipe (Brand New)

goldenboy81 · 07-03-2009, 08:42 PM

These are considered two separate items. You may buy them together or separate.
Email: horan8177@hotmail.com

1. Selling Brand New M6 (M-6) Two Brothers Muffler / Exhaust.
Not a scratch on this baby, never even been mounted, it’s only been taken out of the box (pictures just shows finger prints).
Sold!

2. Selling New (but slightly modified) Header Pipe for Two Brothers M6 (M-6) Yamaha TTR50 Serial # 005-3101H. Got the wrong pipe, tried to mount it on a GPX160cc and had to do some modifications in the process (nothing major). Pipe was heated at the second bend out of the header in order to bend it some (was bent only slightly before I realized the pipe was too short for my setup). See picture for heat marks. I also had to bore out the holes of the plate that holds the exhaust to the header to accommodate larger bolts (see pictures for details). Plate still works fine because nuts hold it tight to header. Worse case, you can get a new plate. Other than that, pipe is in good working order with no scratches. It has never even been ran.
$50 (Shipped)

07-03-2009, 08:42 PM	#1 (permalink)
goldenboy81 PM Newbie Join Date: Dec 2008 Location: Denver, Colorado Posts: 28	Two Brothers Exhaust / Muffler and Header Pipe (Brand New) These are considered two separate items. You may buy them together or separate. Email: horan8177@hotmail.com 1. Selling Brand New M6 (M-6) Two Brothers Muffler / Exhaust. Not a scratch on this baby, never even been mounted, it’s only been taken out of the box (pictures just shows finger prints). Sold! 2. Selling New (but slightly modified) Header Pipe for Two Brothers M6 (M-6) Yamaha TTR50 Serial # 005-3101H. Got the wrong pipe, tried to mount it on a GPX160cc and had to do some modifications in the process (nothing major). Pipe was heated at the second bend out of the header in order to bend it some (was bent only slightly before I realized the pipe was too short for my setup). See picture for heat marks. I also had to bore out the holes of the plate that holds the exhaust to the header to accommodate larger bolts (see pictures for details). Plate still works fine because nuts hold it tight to header. Worse case, you can get a new plate. Other than that, pipe is in good working order with no scratches. It has never even been ran. $50 (Shipped) Last edited by goldenboy81; 07-19-2009 at 08:41 PM.