Planet Minis

79z50420 · 07-27-2008, 06:12 PM

just put on a 1/4 turn throttle on my stocker and it went on great seems to be good throttle response reving it up but when i put it gear it seems to bog bad. SOo bad i can't even do a 1st gear dohnut in loose gravel, seems like it wont let me rev into the power band it even bogs to the point of stalling shifting into second with any bit of load. Bike ran great before the throttle had lots of power so i'm guessing i might need a smaller cable or adjust the **** outta the stock one to get it rev higher?

FastMC · 07-27-2008, 07:02 PM

Did you look down the throat of the carb to see if the slide's opening all the way ?

79z50420 · 07-27-2008, 10:31 PM

no i havn't check that out yet but will tomorrow, so if it nots opening all the way can i adjust it up using the adjuster on the cable?

79z50420 · 07-28-2008, 05:16 PM

tried to look into the carb but where its a 79 you can't really see in there, so i just tightend up the adjustment screw almost as tight as it can go and it seemed like it sucked up the slide a bit but havn't had a chance to run it yet.

07-27-2008, 06:12 PM	#1 (permalink)
79z50420 PM Newbie Join Date: Nov 2007 Location: East Coast Canada fackers!! Posts: 96	1/4 turn throttle problem just put on a 1/4 turn throttle on my stocker and it went on great seems to be good throttle response reving it up but when i put it gear it seems to bog bad. SOo bad i can't even do a 1st gear dohnut in loose gravel, seems like it wont let me rev into the power band it even bogs to the point of stalling shifting into second with any bit of load. Bike ran great before the throttle had lots of power so i'm guessing i might need a smaller cable or adjust the **** outta the stock one to get it rev higher?

07-27-2008, 07:02 PM	#2 (permalink)
FastMC Sporting the Merkin Join Date: Mar 2004 Location: boston area Posts: 5,072 My Mood:	Re: 1/4 turn throttle problem Did you look down the throat of the carb to see if the slide's opening all the way ?

07-27-2008, 10:31 PM	#3 (permalink)
79z50420 PM Newbie Join Date: Nov 2007 Location: East Coast Canada fackers!! Posts: 96	Re: 1/4 turn throttle problem no i havn't check that out yet but will tomorrow, so if it nots opening all the way can i adjust it up using the adjuster on the cable?

07-28-2008, 05:16 PM	#4 (permalink)
79z50420 PM Newbie Join Date: Nov 2007 Location: East Coast Canada fackers!! Posts: 96	Re: 1/4 turn throttle problem tried to look into the carb but where its a 79 you can't really see in there, so i just tightend up the adjustment screw almost as tight as it can go and it seemed like it sucked up the slide a bit but havn't had a chance to run it yet.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)