Planet Minis

Fullthrottle · 12-03-2006, 06:29 AM

another question....

i bought after market perch kit from motion pro... than i bought honda brake cable for both brake front & rear. (for a Z50A-K1 1969 both brake on handlebar).

on the perch the ajuster Ø is lower than cable end insert...

the question is: with same thread does exist different ø for ajuster on the perch?

picture exemple:

for my case the wire end is too big to enter in the ajuster...
any simple solution?

Fullthrottle · 12-03-2006, 07:15 AM

i found a part of the answer... there's two ø... mine are 8mm

12-03-2006, 06:29 AM	#1 (permalink)
Fullthrottle 2nd Gear Member Join Date: Aug 2005 Location: Montréal, Québec, Canada Posts: 424	brake cable question... another question.... i bought after market perch kit from motion pro... than i bought honda brake cable for both brake front & rear. (for a Z50A-K1 1969 both brake on handlebar). on the perch the ajuster Ø is lower than cable end insert... the question is: with same thread does exist different ø for ajuster on the perch? picture exemple: for my case the wire end is too big to enter in the ajuster... any simple solution? Last edited by Fullthrottle; 12-03-2006 at 06:35 AM.

12-03-2006, 07:15 AM	#2 (permalink)
Fullthrottle 2nd Gear Member Join Date: Aug 2005 Location: Montréal, Québec, Canada Posts: 424	i found a part of the answer... there's two ø... mine are 8mm

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)