Planet Minis

bigluelok

alright in my other thread of my build i have stated that i was going to run a 12v motor. well the plans have changed and i will be running a 6volt 88cc motor.


so my question is how do i wire it up?

alright i have the motor bolted up and now i need help with wiring.

Colors from Main Harness
black/red,
solid green x2,
solid white,
blue/white,
solid yellow,
solid red,
solid orange,

and from the Motor

yellow/red,
solid yellow,
solid white, white/red,
green/white,
and a black

big pete

Colors of the wirings coming from the harness and motor would be helpful. Since the stock motor and the 88cc motor are 6v, it's down to matching the colors of the wires together.

bigluelok

updated first post with colors of wiring i have

LoudFastUgly

Did you get a CDI with your 6V engine? Is it points ignition?

bigluelok

how do i tell if its points or not i higly doubt that its a points motor. the Motor came out of a panda. and wouldnt points takethe place of the sark plug

cdoublejj

The point are behind the fly wheel the take place of the cdi not the shark plug.

big pete

The Panda motors are 6v CDI motors.

bigluelok

thanks pete i figured it was a cdi Motor

bigluelok

bump any one know how to wire this up?

dirtbkr188

Why don't you just swap out the stator and flywheel from the Lifan 125 engine that you have, and put it on the 88 engine? You can then use the instructions posted in your other thread about How to wire a Lifan 125 to a Panda Bike

bigluelok

dirtbkr188: Why don't you just swap out the stator and flywheel from the Lifan 125 engine that you have, and put it on the 88 engine? You can then use the instructions posted in your other thread about How to wire a Lifan 125 to a Panda Bike


because i dont have the parts to make the 12volt motor run to begin with or i would have just stayed with the 125

big pete

What was missing for the 125?

bigluelok

everything to make the 12volt runn in the panda so cdi,clutch lever,clutch cable, lightbulbs, rectifer, and a 12 way carb mount

bigluelok

so far this is what i have as far as wiring

Colors from Main Harness MOTOR
black/red,---------------> yellow/red
solid green x2,----------->
solid white, -------------> solid white,
blue/white, ------------->
solid yellow,-------------> solid yellow
solid red, ---------------->
solid orange, ------------>


Whats Left from Motor this is what i need help with figuring out
white/red,
green/white,
and a black

dirtbkr188

Is the Panda a 12V bike, or is it 6V?

big pete

It's 6V

bigluelok

like i said in my first post i was going to swap to 112volt but didnt have the cash for everything so i got the 88cc motor just so i can ride it sooner

big pete

From looking at the diagram I gave you in your build thread, here's what I think is correct:


Didn't you just need the following: 12v CDI, bulbs, rectifier, battery, ignition coil, and flasher relay? It would have came out to about $100 or so.



*Edit - looks like one of the green wires and the red wire is for the battery.

dirtbkr188

I was unaware that the Panda is a 6V bike, now I understand why you didn't use the Lifan engine. My mistake...

bigluelok

its all good man no harm no foul.
and thanks pete i needed that