Planet Minis

blahblah · 02-19-2009, 03:48 AM

Hey guys,

I just picked up a 1987 TRX 70 which I paid a little too much for but they are so hard to find I don't care. These things are getting on now but man they are fun. I'm about to drop a yx150 motor in it and am trying to clean it up a little but I have lots of broken mounts on the plastics.. a few holes that some idiot drilled in them and scratches etc. I was wondering if anyone has had experience in repairing plastics with good results. Any advice etc. Yes I know I could go out and buy new plastics but they cost a lot of $$$ over here(Australia) and the plastics on the bike look good I just want to tidy them up a bit.

Thanks in advance I might post some pictures shortly to show the problem area's.

Cheers

02-19-2009, 03:48 AM	#1 (permalink)
blahblah PM Newbie Join Date: Oct 2008 Posts: 1	TRX 70 Plstics repair advice needed. Hey guys, I just picked up a 1987 TRX 70 which I paid a little too much for but they are so hard to find I don't care. These things are getting on now but man they are fun. I'm about to drop a yx150 motor in it and am trying to clean it up a little but I have lots of broken mounts on the plastics.. a few holes that some idiot drilled in them and scratches etc. I was wondering if anyone has had experience in repairing plastics with good results. Any advice etc. Yes I know I could go out and buy new plastics but they cost a lot of $$$ over here(Australia) and the plastics on the bike look good I just want to tidy them up a bit. Thanks in advance I might post some pictures shortly to show the problem area's. Cheers

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)