How do I jet my MOLKT?

[mx4lifeCR125]

So I have a MOLKT 26mm carb on my YX140. When the clip on the needle is set in the middle groove it wont idle but it feels and sounds right after you touch the throttle. The higher you set it the better it idles but then dies when you give it gas. What jets and in what direction should I jet it?



Thanks!

[PlanetMinis.com]

[SCAR8]

Throw it in the trash and buy a Mikuni VM26 thats how I'm going to jet mine! lol Contact Matt at pitster and they can get you some jets to make it run pretty good!!

[SCHMEEL]

start with a 25 pilot jet. thats were i started

[mx4lifeCR125]

Hey, thanks. I can just pick those up at Pitster?

And ya, I would throw that thing away but I have a very low budget... Like, $10.

[schofell84]

sounds like you have the idle fuel screw tightened in?

[midwest_militia]

The best I can get it is 25 pilot and 120 main (I have bigger motor and V2 head so you may have to go leaner on the main). Air screw about 3/4 - 1 1/4 turn out and the needle 2nd from the bottom with a small shim to let it sit between the bottom and 2nd to bottom clip. I also raised the floats quote of bit.

Hope this helps! This got me by but I have a PWK 28 on the way from Tbolt.

[mspike]

I have the same set up as you and I use a 25 pilot and 115 main I think and it runs great. You may have to adjust the floats though if it bogs after jumping.

[kawasakicoby125]

i have a tb28 ill sell u for CHEAP!